To avoid transportation accidents, the water pump is in a vacuum state when it leaves the factory. After the machine arrives at the store, after checking the equipment and confirming that it is not damaged, the equipment can be officially activated.
For the first use, it should be noted that the pump can only be powered on and used normally after it is filled with water. Only 3 simple manual operation steps to do it as below.
Water shooting machine, small mouth water bottle
Connect the orange tube to the white rubber pad in the original state, first press and hold the white rubber pad to the left, then grab the orange water tube and pull it out to the right,
Put the bottle filled with water against the water inlet of the orange tube and add water until it is full, about 1000 ml,
After adding water, grab the orange water pipe and insert it to the right until it reaches the end, the water addition is completed;